Propellers, stern gear, outboards, inboards

SEAJET products will minimise the fouling growth on these areas. These areas receive a lot of punishment due to cavitation, so repainting can be a required yearly, but it is often worth it to improve speed through the water. Our systems are the same for all surfaces, whether bronze, aluminium or plastic.

Pre-treatment:
Remove all old antifouling and contamination from the surface to be coated. Degrease well and rinse with fresh water. For bronze surfaces: Key the surface by abrading using 80–120 grade abrasive wet and dry. For aluminium, factory painted outboards and out drives: P-220 abrasive paper is recommended to provide a physical key.

Antifouling option: SEAJET Triple Pack

No. of
Coats
Product nameCoating interval
at 10°C min/max
Thinner/
Cleaner
Abrasive
Paper
Comments
1SEAJET Propeller
Primer
12 hrs/3 daysThinner ENone Improves
adhesion of
antifouling
Then


2SEAJET 034
Emperor
Antifouling
12 hrs/NoneThinner ANoneCan be applied
directly to bronze
propellers

Leave 18 hours before launching. Maximum interval before launching is 6 months.
For bronze, alloy, aluminium and stainless steel surfaces.
Coverage rate per pack is 2,5 m²/lt.


Foul Release Option – SEAJET Pellerclean

No. of
Coats
Product nameCoating interval
at 10°C min/max
Thinner/
Cleaner
Abrasive
Paper
Comments
1SEAJET Propeller
Primer
12 hrs/3 daysThinner EP80Sanding before application
2SEAJET Speed7 hrs/5 daysThinner ADo not
sand


Leave 8 hours before launching. Maximum interval before launching is 6 months.
Please don’t over protect the propeller with anodes, for advice please contact Seajet.
Watch our video ‘How to apply Seajet Pellerclean‘ on our website.
Note: the above products come boxed as Seajet Pellerclean, complete with primer and finish.

TIP: Be careful not to coat the anodes.